The original daewootech forum

dear mmamdouh

your fuel tank has no drain plug and it is localy manufactured (frank-sami) you must remove it and clean it. i already do that job.

why change CTS if the gague inside the car work in good condition

is that possible to slect four good injectiors from the eight ones to use

dear mamdouh

did you notice any varyation in the sound of the fuel pump disturbance with the engine dumb.

because i noticed that and change the pump with no change

sorry for writting wrong part numbers the corrected numbers are
champion RN9YC
or NGK BPR6ES
BOSCH WR7DC

Kimo

you can also use bosch WR7DC it is equivalent to champion RN9YS and NGK PBR6ES

Kimo

Hi

i want to know the reason for the god acceleration in cold weather than in hot one.

is that may due to bad oxygen sensor of water temperature sensor or any thing else.

Thanks

ok i found the way of reset the ECU in how to do part. and i will try this today and tell you tomorrow.

but from two weeks ago i cleaned the idle then remove the +ve cable of battary for 1 min. then reconnect is that enough? because there is no change.

Thanks

how can reset my ECU, is it by remove the positive cable for about 1 min. only?
thanks

As i remember it cost arround 180 LE. ar less

her is a copy from whatvi read Car Runs but Won't Re-Start; Bad RPM Sensor. I recently posted a starting problem with a 1991 240, where it would start fine when it was cold and would start fine hot if restarted immediately after cutting off the engine. However, if it were left for 10 minutes or more...

yes this what i am thinking to every time i check the fuel filter i found it very dirty but may be there is somthing wrong other than injectors, becuse at last time i went to the agency at abou rawash i noticed that about 80% of lanos or nubera cars have delay in start. and i have fried who has nube...

hi every body

i want to know the model of other car that i can use their injectors (equivalent) in my lanos 1.5L (s type) model 1999.

or the part number of bosch injectors

thanks

kimo

dear sir

are you have the old problem with the new installed injectors

i tried use Bosch WR7dc it is good i prefer it more than NGK bpr6es because it is just made in germany.