nubira with no power help needed plsss

[dady619]

ok first sorry to be a pain. this morning i took out the 02 sensor and started the car it would idle bet just and would not rev up at all till the car warmed up and even then not much reves at all im going to check the timing . i pulled of the fuel fillter and there was heaps coming out lol if there is anything u could think for me to check please let me no also were is the timing marks thanks ps iv been on the net trying to find out what it could be but not much luck

[dady619]

just pulled out a plug and it is very black timing?also i just seen that the crank pully seems to be moving from side to side not in and out could that be the pro as there is a crank sensor down there again sorry if im asking to much

[dady619]

well i think il give up. anyone what to buy it ?6 months rego nsw

[benzino]

did you manage to get it to the mechanic?

[dady619]

no not yet il ring the only 1 we have in town and see if he can check it but he may not have the machine to check it

[benzino]

hopefully you will be able to get it fixed
and hopefully it's just something simple

[dady619]

well its of the the shop tomorow i just hope they can tell me what it is and today it want even start hope the machine works with the motor not runing there is a lot of poping in the air fillter box timing? if so how can i set it thanks

[dady619]

well i got the car back today and it still ant going. he did a test on it and it did not show anything but he thinks it is the crank sencor now the car want even start what would be the first think u would change on it thanks il try ony thing at a time

[Big Jeff]

well i got the car back today and it still ant going. he did a test on it and it did not show anything but he thinks it is the crank sencor now the car want even start what would be the first think u would change on it thanks il try ony thing at a time

if the starter is engauging the i would change the crank sensor first.... as is the crank sensor that tell the ecu the engine is turnin over...

is i had power problems when my cat was blocked,, your pre car is mounted between exhaust manifold and the front down pipe

[dady619]

it was glowing red from the exhaust manifold to a small joining pipe like a flex pipe? even with th 02 sensor out it still ran bad but now it dont even run thanks

[dady619]

well today i put in a new 02sensor and a new crank sensor and still no good im very very stumped what could i change or check next also as i do think it is the timming how can i check the timing were r the timing marks any help would be grate thanks

[Big Jeff]

is the starter motor turn the engine over?

[Big Jeff]

is the exhaust manifold sealed, make sure there is no air leaks. if there is a air leak you o2 sensor will read there being o2 in the gas and and add more fuel,

if they in more feul being burned it make the exhause really hot and could expand why it glowing red.

[dady619]

it dont start no more so i dont no but it seem to be poping out the air fillter and the air fillter is burnt

[Big Jeff]

check to see if you ERG value is open or burned..

and it seems your timming is out, on th FAQ borad the is a link to the service manual.
it sound like it was misfiring in the inlet manfold, so you make have ruined your injector. that might explain why your enginr is not starting.