use a dremel... am i right???????
i was thinking cut off the plastic and then make sure you put TONS of epoxy in your aftermarket handle and use a mallet to get it on :lmao:
My Maltese Lanos
Moderators: daewoomofo, Moderators Group
-
Audacity Racing
- moron
- Posts: 4493
- Joined: Wed Dec 08, 2004 5:18 am
- Location: Knoxville, Tennessee
- Contact:
-
blackielaw
- Junior
- Posts: 132
- Joined: Sat Mar 06, 2004 6:10 pm
The model I chose didn't fit over the stock brake so I cut the stock rubber off with a wire cutter and slipped the new brake in. Didn't need to use any glue or mallets or anything.Brian5475E wrote:how did you get that factory e brake handle off?
"Life is hard; it's harder if you're stupid."
1999 Lanos
(The only modified Lanos in Malta)
1999 Lanos
(The only modified Lanos in Malta)
Nice wooo
Very nice woo
I want to ask you from where you get the new GM daewoo logo
what does it cost?
and how Can I get two of them in my place (Egypt)?
a.k.n
I want to ask you from where you get the new GM daewoo logo
what does it cost?
and how Can I get two of them in my place (Egypt)?
a.k.n
-
blackielaw
- Junior
- Posts: 132
- Joined: Sat Mar 06, 2004 6:10 pm
Re: Nice wooo
I suggest you contact Tom at 360 Dynamics on this forum. He should be selling them and will ertainly be able to give you all the details you requirenefary wrote:Very nice woo
I want to ask you from where you get the new GM daewoo logo
what does it cost?
and how Can I get two of them in my place (Egypt)?
a.k.n
"Life is hard; it's harder if you're stupid."
1999 Lanos
(The only modified Lanos in Malta)
1999 Lanos
(The only modified Lanos in Malta)