you will need a flat end screw driver and cross end screw driver
1- pop the electric mirror control panel with a flat end screw driver then detach its socket (if you don't have that accessory then you will have a cup shaped plastic trim... put your for fingers in it and pop it out of place
2- remove both screws behind the mirror control panel/plastic trim
3- turn the steering wheel 90 degrees to the right and remove the screw behind the wheel shown in the pic
4- turn the wheel 180 degree to the left and remove the other screw shown in pic
5- remove the upper part of the steering column trim by pulling it upwards
6- remove the two screws in the top of the gauge area
7- open the cup holder and pop the bottom of the H shaped trim around the cassette by fingers
8- remove the upper part of the H trim by hand
9- remove the screws of both the cassette and the plastic trim underneath it
10- drag the cassette to the outside
11- remove both lower screws of the A/C control panel
12- pull the bottom of the A/C panel to the outside then move it downwards
13- remove both screws at the bottom of the dash
14- pull the whole dash to the outside, note that you will have to detach the sockets of the hazard light and the clock/rear fog light (if equipped)
15- clear the steering wheel and remove the dash face out of the way
16- remove all 4 screws holding the gauge cluster
17- tilt the cluster face down and remove the 3 sockets in its back
18- clear the steering wheel and remove the whole cluster
MMamdouh
How To: Take off dash and gauge cluster
Moderators: daewoomofo, Moderators Group
How To: Take off dash and gauge cluster
Driving is the utmost fun you can have with your pants on!
Check out my ride: http://www.cardomain.com/ride/567267
Check out my ride: http://www.cardomain.com/ride/567267