Transmissions, Clutches, torque converters, Gear ratios, Brakes, Pads, etc.
Moderators: daewoomofo , Moderators Group
BeaArthur
Posts: 24 Joined: Wed May 05, 2004 12:38 pm
Location: Ottawa
Post
by BeaArthur » Tue Aug 24, 2004 4:29 am
Does anyone know the two different sizes of the six-point socket/hex head needed to remove the four bolts on the caliper above?
BeaArthur
Posts: 24 Joined: Wed May 05, 2004 12:38 pm
Location: Ottawa
Post
by BeaArthur » Tue Aug 24, 2004 12:23 pm
That would probably help, eh? Whoops. My car's a 99 Lanos 1.5L.
GsiTurbo
Super Moderator
Posts: 1791 Joined: Thu Mar 13, 2003 10:56 pm
Location: Edmonton, Alberta, Canada
Contact:
Post
by GsiTurbo » Tue Aug 24, 2004 1:29 pm
hmm....this is a picture of my Saab big-brake conversion. Size-wise, its a hex key, and there was one that fit like a glove in my set. But I really dunno what size it was
__________________________
2002 Lanos 1.5 SOHC... stock!!!
daewooluvr
Expert
Posts: 3052 Joined: Fri Mar 28, 2003 3:51 am
Location: York, PA
Contact:
Post
by daewooluvr » Tue Aug 24, 2004 2:46 pm
I believe it was 14mm.
Wolf-Spirit
Expert
Posts: 375 Joined: Fri May 07, 2004 1:19 pm
Location: Belgium
Post
by Wolf-Spirit » Tue Aug 24, 2004 5:23 pm
14mm? i could swear its 10mm? :s could be wrong though
daewooluvr
Expert
Posts: 3052 Joined: Fri Mar 28, 2003 3:51 am
Location: York, PA
Contact:
Post
by daewooluvr » Tue Aug 24, 2004 5:26 pm
14mm hex key for the ones holding the caliper to the bracket. I can't remember what the size is holding the two halves of the caliper together. Also I think I had bolts and not hex for the other those..