I just installed new guages... The dash was the easy part... Now the speedometer will either read 40 while not moving, or it wont work at all...
I need to know what to do to get them set the right way
thanks
guage trouble
Moderators: daewoomofo, Moderators Group
-
- Posts: 11
- Joined: Wed Dec 04, 2002 4:44 pm
guage trouble
! Is that a Civic? No...
! Is that a BMW? No...
What is that???
"I can't tell, it's to far ahead of us"
! Is that a BMW? No...
What is that???
"I can't tell, it's to far ahead of us"
-
- Expert
- Posts: 3052
- Joined: Fri Mar 28, 2003 3:51 am
- Location: York, PA
- Contact:
-
- Super
- Posts: 219
- Joined: Wed Jan 28, 2004 3:05 am
- Contact:
2 different ways to recalibrate-warning its a mission
2 different ways u can recalibrate....both ways are a mission......
1st way- find an empty 2 lane desserted road or strip. U will need a friend to drive side by side with you.....then u guys agree on a particular speed,,,let's say 25.......u guys drive side by side at the same speed, and when u guys are going 25 he yells it out, and another person (or if your brave and have steady hands) then places your speedo needle at 25....2nd way-..another way is to drive in reverse like for 40 feet and then just place the speedo at 0 mph. It will probably take several attempts.......but this is the way I did mine with my friend vince, and my gauges are very accurate only off my about 2-3 mph
1st way- find an empty 2 lane desserted road or strip. U will need a friend to drive side by side with you.....then u guys agree on a particular speed,,,let's say 25.......u guys drive side by side at the same speed, and when u guys are going 25 he yells it out, and another person (or if your brave and have steady hands) then places your speedo needle at 25....2nd way-..another way is to drive in reverse like for 40 feet and then just place the speedo at 0 mph. It will probably take several attempts.......but this is the way I did mine with my friend vince, and my gauges are very accurate only off my about 2-3 mph
-
- Posts: 11
- Joined: Wed Dec 04, 2002 4:44 pm