need help now please!!!

BCC423 · Post by **BCC423** » Sat Nov 12, 2005 5:58 pm

i bought my new valve cover gasket, and installed it, but when i put some of the nuts on, they tighten a little, then start spinning on the stud, what size is the stud on the head that holds the valve cover on, and what size nut do i need, all the 4mm nuts are going on normal, but non thightening up, please help soon please!

BCC423 · Post by **BCC423** » Sun Nov 13, 2005 12:43 am

well, now it turns out that one of the studs are broken off in the head, i got the broke stud out with an extractor bit, but, now i need new studs, where can i find em, gm-car-parts doesnt have em, now my daewoo's dead, but i think i could replace the studs with 4.0mm bolts, if i cant find studs for them

lanos2001 · Post by **lanos2001** » Sun Nov 13, 2005 1:05 am

try tom at 360dynamics i think he has some not sure though.

nick