Leganza Sterio buttons not working

gurugee · Post by **gurugee** » Mon Jul 30, 2007 4:47 am

hi all,

i reset my battery and now i cannot enter my code to setup, since its (12345678- only) no , buttons not woking. it shows me RF(or AF) and i cannot press anything to enter my code to on setup.

(earlier when RF(or AF) display i press 4 and then it ask me the code then i enter code as 4263 but now i cannot do this)

i can see all my lights working on the Amp just down the setup and setup light also working ( it has small red light blinking)

please help me, what should i check?

( this is Daewooo leganza DOHC 2000 car)

Spider · Post by **Spider** » Mon Jul 30, 2007 6:14 am

If you have a small fuse panel in the interior "kick-panel" (drivers-side in the USA)
Than..........
Try this;
Turn the key and the radio off than remove the cover and look at the inside of it for the placement of two (10 amp fuses) that say; "audio"
Actually ? one will say 'audio" and the other will say; "audio-ign")
Remove them (clean and/or replace them) and try it again.
Use a fuse puller and you don't need to disconnect the battery to do this.

happy tunes !

gurugee · Post by **gurugee** » Mon Jul 30, 2007 6:40 am

hi,
tkx for the help i checked that and saw Audio Clock, Audio Imoberlizer, Audio, i remove all and chek it again but still the same. anything that i can check?

please help

gurugee · Post by **gurugee** » Mon Jul 30, 2007 9:21 am

sorry mate i just double check my inter fuse Box, it has

Audio Clock 10A
Audio interlock 10A

i change it but still the same? i cant press 12345678 buttons to enter code

please help

gurugee · Post by **gurugee** » Wed Aug 01, 2007 7:13 am

can anyone tell what to do? please i need your help.

i clean the setup too and check 2 fuses as i mentioned but still its same.

WooJD · Post by **WooJD** » Wed Aug 01, 2007 3:05 pm

This dosnt sound like a fuse problem

Do you have any warranty on the radio?
Do you know much about the electronics inside the radio?

I'm guessing not to both... You most likely have two options:

1. Get a qualified technician to repair it

2. RECOMMENDED Attempt to bash the face a few times, presss buttons extremely hard etc. If not, buy a new one.

Realistically, it's cheaper these days to buy a new unit than to get one repaired.