Kalos/Aveo/Lanos/Lacetti (1.6) Con Rod and Piston

xiaogary · Post by **xiaogary** » Mon Dec 24, 2007 7:29 pm

I need a set of pistons, and con rods with bearings.

If I am not wrong, Daewoo Kalos, Aveo, Lanos and Lacetti (1.6) share the same mid engine block with same crankshaft and piston and con rod.

So I just need one set from any. Preferbly from a 1.6DOHC with 79.0mm bore.

Anyone knows whats the biggest bore an Aveo F16D3 block can take? Is it 80.mm or 80.5mm?
I am planning to bore my 1.4 DOHC (77.9mm bore) to 80.0mm and purchase custom piston (80.0mm pistons).
Also planning to stoke it to 81.5mm. Curently stoke is 73.4mm. Just bought a Lanos Crankshaft with 81.5mm stroke.

Anyone know what is the hole (center) to hole (center) distance for aveo F16D3 cpn rod? I need this data.

I can arrange for shipping once u send the items to a postal company in Oregon or you can send the items to me direct (preferred).

Thanks.
Gary (from Singapore).

xtreme 2 · Post by **xtreme 2** » Mon Feb 04, 2008 7:23 am

got a complete block in the backyard that i am using for mock-ups... What are you offering for them?

I know the pistons can go up to 82mm max...

gse_turbo · Post by **gse_turbo** » Tue Feb 05, 2008 7:10 pm

the max bore for a 1.6 is 82mm per that MLS head gaskets I have available from Cometic.

aslo if you are interested I am putting a group buy on custom pistons from Wiseco. you can get any compression ratio and bore you want with rings and pins for $525 shipped. if that is what you are needing the pistons for then the work is done for you.

xiaogary · Post by **xiaogary** » Wed Feb 20, 2008 4:58 am

Yes. I am interested. But I cannot find a spare piston to send to Wiseco.
Can bore until 82mm?

I already have a 81.5mm stroke 1.6 lanos crankshaft with me now. Waititing for the pistons and rods only currently.

Mine current piston is only 77.9mm and stroke from my 1.4 engine crankshaft is only 73.4mm.

How do I join in the grouop buy? $525 for pistons and pins and rings?

gse_turbo · Post by **gse_turbo** » Wed Feb 20, 2008 6:20 pm

Well I believe that I have the OE piston situated so that is fine.

for the group buy all I need is the payment and the pistons will be started and posted in about 5 weeks

I didn't know this when I posted the first time but I also have Pauter "x beam" steel rods available if you still need rods the cost about $780