Help! CV/Ball Joints

jl4n3 · Post by **jl4n3** » Thu Mar 06, 2008 2:42 am

I am replacing my driver side lower control arm. I have to remove the CV Axle from the transmission so I can get to a long bolt.

I can not for the life of me pull the axle from the transmission! I have plenty of wiggle room...i took the hub assembly off of the strut so I just have connected tie rods but I have more than enough room for the axle to come out but it wont budge...

I tried putting car in park and neutral but nothin...someone please give me the tip!! I appreciate anyone's help!!!!!

FYI I drive a 2k1 Nubira SE THanks!

jl4n3 · Post by **jl4n3** » Thu Mar 06, 2008 12:53 pm

So no one here knows how I can remove my axle from the transmission? Is there any special clamp or pin i need to remove? SHould my tranny be in P, N, D, R, or anything else?

MMamdouh · Post by **MMamdouh** » Sun Mar 09, 2008 9:38 am

i never worked on an auto tranny... sorry

MMamdouh

daewoomofo · Post by **daewoomofo** » Sun Mar 09, 2008 4:19 pm

from what i remember you just have to kinda pull it back and forth, when i was working on my front suspension on the red woo, my passenger side just fell out and i was likd WTF, i broke some thing! but i stuck it back in, made sure it seated all the way and never had a problem.

jl4n3 · Post by **jl4n3** » Tue Mar 11, 2008 11:36 pm

Passenger side fell right out but I had to get a bit rough with the driver side but I got it lol. Thanks fellas!