THE MOST POWERFUL TURBO C20XE ....614WHP!!!
Moderators: daewoomofo, Moderators Group
-
- Moderator
- Posts: 4795
- Joined: Fri Nov 18, 2005 1:41 am
- Location: 313
- greenbluewoo
- Expert
- Posts: 375
- Joined: Thu Sep 23, 2004 7:44 pm
- Location: New Hampshire
- Contact:
-
- Moderator
- Posts: 4795
- Joined: Fri Nov 18, 2005 1:41 am
- Location: 313
are you talking about the one with the 1 piece fiberglass front clip?.........
http://www.daewootech.com/forum/viewtop ... hlight=mk2
http://www.daewootech.com/forum/viewtop ... hlight=mk2
Ahaaa, thats why I couldnt find it. I tried searching 9sec, 9 sec, 9 second and 9second aswell as astra, mk2 etcetc. Fucking 8 seconds!
Yeah thats the one though. Looks to be based around an LET from what I seen in the pics.
Ok, not much LET left in there I bet, but it is based around that. Yummy.
Yeah thats the one though. Looks to be based around an LET from what I seen in the pics.
Ok, not much LET left in there I bet, but it is based around that. Yummy.
SAZ
---------------------
---------------------
4T40-E / 4T45-E GENERAL MOTORS FRONT WHEEL DRIVE
Cavalier, Malibu, Cutlass, Alero, Grand Am, Sunfire
Valve bodies are custom calibrated to provide firm, efficient shifts.
Modified pressure regulation system to furnish precise line pressure increase as needed with open throttle conditions.
Redesigned converter clutch apply circuit to yield greater holding capacity under high horsepower use.
New Solenoids installed
Modified pressure control solenoid installed (4T65E)
Additional Clutches Installed
Hi-Energy Friction Material Installed
Modified pump to increase volume and enhance fluid flow throughout the unit.
Heat treated pump driveshaft to prevent spline stripping
Heat treated apply sleeve to prevent breakage
Modified aftermarket front sun gear to prevent the pitting and galling often associated with the OEM part.
Heat treated final drive sun gear to prevent the metal fatigue associated with the OEM part.
New Torrington Bearing set installed to reduce frictional losses and prevent component failure
High strength drive chains utilized to prevent stretch and skipping teeth.
Limited Slip Differential available (optional)
4T40-E and 4T45-E: $2975
http://www.importperformancetrans.com/gmautofwd.shtml
This is one company but I don't think the one I posted above is the 600 hp one...i think they said it was good to around300-350hp.
Jimmy
Cavalier, Malibu, Cutlass, Alero, Grand Am, Sunfire
Valve bodies are custom calibrated to provide firm, efficient shifts.
Modified pressure regulation system to furnish precise line pressure increase as needed with open throttle conditions.
Redesigned converter clutch apply circuit to yield greater holding capacity under high horsepower use.
New Solenoids installed
Modified pressure control solenoid installed (4T65E)
Additional Clutches Installed
Hi-Energy Friction Material Installed
Modified pump to increase volume and enhance fluid flow throughout the unit.
Heat treated pump driveshaft to prevent spline stripping
Heat treated apply sleeve to prevent breakage
Modified aftermarket front sun gear to prevent the pitting and galling often associated with the OEM part.
Heat treated final drive sun gear to prevent the metal fatigue associated with the OEM part.
New Torrington Bearing set installed to reduce frictional losses and prevent component failure
High strength drive chains utilized to prevent stretch and skipping teeth.
Limited Slip Differential available (optional)
4T40-E and 4T45-E: $2975
http://www.importperformancetrans.com/gmautofwd.shtml
This is one company but I don't think the one I posted above is the 600 hp one...i think they said it was good to around300-350hp.
Jimmy
- Nubaroo
- Expert
- Posts: 387
- Joined: Wed Nov 14, 2007 7:35 am
- Location: South Africa - Chasing my 11sec 1/4 mile!!!
From what I know here in SA - this Opel is running an F28 Getrag gearbox with a Quiaffe LSD - like I said in another post....these trannies can handle pretty much anything one can throw at them If anyone beggs to disagree, I can get to Nassen, speak to him personally and maybe take some pics as well????
Nothing is impossible....it just costs more!!!!\
No matter how much money you spent on ur car.....there will always be sombode FASTER!!!!
368KW/611Nm on wheels @ 2.4bar
No matter how much money you spent on ur car.....there will always be sombode FASTER!!!!
368KW/611Nm on wheels @ 2.4bar